Kia Niro: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement
  

When installing the belt, be careful not to damage the retractor.

1.

Remove the rear pillar trim.

(Refer to Interior Trim - "Rear Pillar Trim")

2.

Remove the rear seat belt upper anchor (A) after loosening the mounting bolts.

Tightening torque :

39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

3.

Remove the rear seat belt retractor (A) after loosening the mounting bolt.

Tightening torque :

Lower : 39.2 - 53.9 N·m (4.0 - 5.5 kgf·m, 28.8 - 39.8 lb·ft)

Upper : 7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

4.

Install in the reverse order of removal.

  

Make sure the connector is plugged in properly.

Replace any damaged clips (or pin-type retainers).

Rear Seat Belt Retractor Components and components location
Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and components location
Component Location 1. Rear center seat belt retractor ...

Other information:

Kia Niro (DE HEV) Owners Manual: Fuel Gauge
■ Type A ■ Type B This gauge indicates the approximate amount of fuel remaining in the fuel tank. ✽ NOTICE The fuel tank capacity is given in chapter 9. The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty. On in ...

Kia Niro 2017 (DE HEV) Service Manual: Side Impact Sensor (SIS) Description and operation
Description • Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH) and two rear SI ...

© 2016-2023 www.kniro.net