Kia Niro: Rear Bumper / Rear Bumper Cover Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the combination lamp cover (A).

2.	Remove the rear combination lamp (A) after loosening the mounting screws.

3.	Remove the waterproof seal (A).

4.	Disconnect the rear combination lamp connector (A).

5.	Loosen the rear bumper upper mounting fastener.

6.	Remove the rear bumper side after loosening the screw and fastener.

7.	Remove the wheel guard mounting clip (A).

8.	Remove the rear bumper side under cover (A). [LH] [RH]

9.	Loosen the mounting bolts.

10.	Disconnect the rear bumper main connector (A).

11.	Remove the rear bumper cover (A).

12.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Rear Bumper Cover Components and components location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Other information:

Kia Niro (DE HEV) Owners Manual: Cleaning the leather seats
Remove all contaminations instantly. Refer to instructions below for removal of each contaminant. Cosmetic products(sunscreen, foundation, etc.) - Apply cleansing cream on a cloth and wipe the contaminated point. Wipe off the cream with a wet cloth and remove water with a dry cloth. B ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components 1. Front pillar trim 2. Front door pillar trim 3. Center pillar upper trim 4. Rear door scuff trim 5. Cowl side trim 6. Center pillar lower trim 7. Rear pillar trim ...