Kia Niro: Rear Bumper / Rear Bumper beam Assembly Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Be careful not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Disconnect the rear bumper beam mounting wiring harness (A).

3.	Remove the rear bumper beam assembly (A) after loosening the mounting clips.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Rear Door

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components 1. Cowl cross bar assembly 2. Main wiring harness 3. Main crash pad assembly 4. Side speaker grille assembly [RH] 5. Steering column shroud lower pannel 6. Center speaker grille assembly 7. Side speaker grille assembly [LH] 8. Cras ...

Kia Niro (DE HEV) Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location. 2. • Connect connection hose (10) of the compressor directly to the tire valve. (18 inch tire only) • Connect the filling hose (3) of the compressor (clip mounted side) directly and then ...