Kia Niro: Engine Control System / Rail Pressure Sensor (RPS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS) Repair procedures

Inspection

1.	Connect the KDS/GDS on the Data Link Connector (DLC).

Measure the output voltage of the RPS during idle at various engine speeds.

Pressure		Output Voltage (V) [Vref=5V]
bar	[MPa (kgf/cm², psi)]	Output Voltage (V) [Vref=5V]
0	0 (0, 0)	0.5
140	14 (142, 2031)	2.5
280	28 (286, 4061)	4.5

Removal

1.	Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”).

2.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

3.	Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")

4.	Remove the injector foam.

Disconnect the rail pressure sensor connector, and then remove the sensor (A) from the delivery pipe.

Rail Pressure Sensor :

30.0 - 34.3 N·m (3.0 - 3.5 kgf·m, 22.1 - 25.3 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.	Install in the reverse order of removal.

Rail Pressure Sensor (RPS) Schematic diagrams

Circuit Diagram Harness Connector ...

Rail Pressure Sensor (RPS) Troubleshooting

Signal Waveform ...

Other information:

Kia Niro (DE HEV) Owners Manual: Light bulb position (Rear)
■ Rear combination lamp - Type A ■ Rear combination lamp - Type B ■ Back up lamp ■ License plate lamp ■ High mounted stop lamp (1) Stop/tail lamp(Bulb type) (2) Tail lamp(Bulb type) (3) Rear fog lamp(LED type) (4) Rear turn signal lamp (5) Stop/tail lamp(LED type) (6) B ...

Kia Niro (DE HEV) Owners Manual: START/RUN
Not illuminated To start the engine, depress the brake pedal and press the engine start/stop button with the shift lever in the P (Park) or the N (Neutral) position. For your safety, start the engine with the shift lever in the P (Park) position. ✽ NOTICE If you press the engine start/sto ...