Kia Niro: Engine Control System / Rail Pressure Sensor (RPS) Description and operation
| Description |
Installed on the delivery pipe, the Rail Pressure Sensor (RPS) measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure is different from the actual pressure calculated by the RPS output signal.
Rail Pressure Sensor (RPS) Specifications
Specification
Pressure
Output Voltage (V) [Vref=5V]
bar
[MPa (kgf/cm², psi)]
0
0 (0, 0)
0 ...
Rail Pressure Sensor (RPS) Schematic diagrams
Circuit Diagram
Harness Connector
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components Location
1. Front axle
2. Stabilizer bar
3. Gear box
4. Drive shaft
5. Subframe
6. Stabilizer link
7. Front lower arm
...
Kia Niro 2017 (DE HEV) Service Manual: Rear Washer Motor Repair procedures
Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
Before filling the reservoir tank with water, check the filter
...
