Kia Niro: Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection

1.	Switch "OFF" the ignition.

2.	Disconnect the PCSV connector.

3.	Measure resistance between the PCSV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: 14.3 - 14.7 Ω [20°C(68°F)]

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the purge control solenoid valve connector (A).

4.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

5.	Remove the purge control solenoid valve.

Installation

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

1.	Install in the reverse order of removal.

Purge Control Solenoid Valve (PCSV) Schematic diagrams

Circuit Diagram Harness Connector ...

Variable Force Solenoid (VFS) Description and operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calc ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting Symptom Probable cause Remedy Play in steering Loose yoke plug Retighten Loose steering gear mounting bolts Retighten Loose or worn tie rod end ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Removal In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials. 1. Disconnect the negative (-) battery terminal. ...