Kia Niro: High Voltage Battery Control System / Pre-Charge Relay Description and operation
| Description |
Built into the Power Relay Assembly (PRA), the Pre-Charge Relay starts to charge the capacitor of the inverter soon after ignition "ON", then it goes out when the capacitor has been fully charged.
|
1. High Voltage Power Terminal (-) 2. High Voltage Power Terminal (+) 3. Battery Current Sensor 4. Inverter Power Terminal (-) 5. Inverter Power Terminal (+) 6. Pre-Charge Resistor |
7. Main Relay (+) 8. Pre-Charge Relay 9. Main Relay (-) 10. Power Relay Assembly Connector (Battery current sensor signal input) 11. Power Relay Assembly Connector (Main relay control) |
| [PRA Operation Sequence] |
Pre-Charge Relay Specifications
Specification
Item
Specification
Contact
Rated Voltage (V)
450
Rated Current (A)
10
...
Pre-Charge Relay Schematic diagrams
Circuit Diagram
...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Dynamic Damper Components and components location
Components
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ housing
13. T ...
Kia Niro 2017 (DE HEV) Service Manual: Sub Frame Repair procedures
Removal
1.
Disconnect the battery negative cable.
2.
Remove the universal bolt (A).
Tightening torque :
32.4 - 37.3 N·m (3.3 - 3.8 kgf·m, 23.9 - 27.5 lb·ft)
...
