Kia Niro: Seat Electrical / Power Seat Motor Repair procedures

Inspection

Power Seat Motor

1.

Disconnect the connectors for each motor.

[Slide motor (A)]

[Rear height motor (B)]

[Front tilt motor (C)]

[Reclining motor (D)]

[Lumber support motor (E)]

2.

When the battery power is supplied to the motor connector, check the motor for smooth operation.

3.

Reverse the connections and check that the motor turns in reverse.

4.

If the motor runs abnormally, replace it.

[Driver]

Reclining Motor Limit Switch

1.

Disconnect the limit switch and operate the limit switch.

2.

Check for continuity between the terminals.

3.

Make sure that the seat operation is normal in the reverse after the maximum operation.

4.

If there is an abnormality, replace the limit switch.

Remove

Front Seat

1.

Disconnect the negative (-) battery terminal.

2.

Remove the front seat assembly.

(Refer to Body - "Front Seat Assembly")

Power Seat Motor Description and operation
Description Power seat motor is driven by a motor in the following. 1. Slide motor 2. Front tilt motor 3. Rear Height ...

Power Seat Control Switch Schematic diagrams
Circuit Diagram [Driver power seat switch] (Non-IMS Type) (IMS Type) ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description Body Control Module (BCM) function No Item Description 1 Washer Linked Wiper – If the washer switch is pressed ON for 0.06-0.2 second with the vehicle mode in IG ...

Kia Niro 2017 (DE HEV) Service Manual: Variable Force Solenoid (VFS) Repair procedures
Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Disconnect the VFS connector (A). 3. Remove the mounting bolts (B), and then remove the VFS from the engine. ...

© 2016-2025 www.kniro.net