Kia Niro: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Remove the glove box assembly. (Refer to Body (Interior and Exterior) - "Glove box housing")

Remove the PAB mounting bolts.

Tightening torque:

8.8 - 10.8 N.m (0.9 - 1.1 kgf.m, 6.5 - 8.0 lb-ft)

4.	Disconnect the passenger airbag connector (A).

Remove the main crash pad.

(Refer to Body (Interior and Exterior) - "Main crash pad assembly")

If the PAB has been deployed, replace the damaged crash pad.

Loosen the Passenger airbag module mounting bolts (2) Remove the passenger airbag module.

Tightening torque:

3.9 - 5.9 N.m (0.4 - 0.6 kgf.m,2.8 - 4. 3 lb-ft)

Remove the air bag modules are placed so that the airbag cover side facing up

Installation

1.	Install in the reverse order of removal

After installing the airbag module, ensure that the airbag system is operating normally.

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off

Passenger Airbag (PAB) Module Components and components location

Components 1. Passenger Airbag (PAB) ...

Side Airbag (SAB) Module Description and operation

Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of sid ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Inspection 1. Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2. Check for continuity between the terminals. 3. If continuity is not specifi ...

Kia Niro 2017 (DE HEV) Service Manual: Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) ba ...