| Removal and Installation |
| 1. |
Disconnect the battery negative terminal. |
| 2. |
Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") |
| 3. |
Disconnect the oil pressure switch connector (A). |
| 4. |
Remove the oil pressure switch (B).
|
| 5. |
Install in the reverse order of removal.
|
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
| 3. |
If there is no continuity when a pressure of 50 kPa (0.50 kgf/cm², 7.25 psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Oil Cooler Repair procedures
Oil Level Gauge & Pipe Repair proceduresKia Niro (DE HEV) Owners Manual: Roof rack
If the vehicle has a roof rack, you can load cargo on top of your vehicle.
Crossbars and fixing components needed to install the roof rack on your vehicle
may be obtained from an authorized Kia dealer or other qualified shop.
✽ NOTICE
The crossbars (if equipped) should be placed in the p ...
Kia Niro 2017 (DE HEV) Service Manual: Gear Actuator Assembly Description and operation
Description
•
The gear actuator comprises the shift motor and select solenoid.
•
Gear actuator shift motor and select solenoid use signals from TCM to
control the gear.
...