Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the driver front door trim. (Refer to Body - "Front Door Trim") |
3. |
Remove the memory power seat switch (A) after loosening the mounting screws.
|
Installation |
1. |
Install the memory power seat switch (IMS). |
2. |
Install the driver front door trim. |
3. |
Connect the negative (-) battery terminal. |
Inspection |
1. |
Remove the memory power seat connector.
|
2. |
When each switch is pressed, check the electricity flow between memory power seat switch connector and grounding, and if the electricity does not match the specification, replace the switch.
|
Kia Niro (DE HEV) Owners Manual: Distributing the sealant
11. Immediately drive approximately 7~10km (4~6miles or, about 10min) to evenly
distribute the sealant in the tire.
CAUTION
Do not exceed a speed of 60 km/h (35 mph). If possible, do not fall below
a speed of 20 km/h (12 mph).
While driving, if you experience any unusual vibration, ride distu ...
Kia Niro 2017 (DE HEV) Service Manual: Clutch Actuator Assembly Components and components location
Components
1. Fork cover
2. Clutch actuator assembly
3. Extension connector
4. Motor 1 (Odd)
5. Motor 2 (Even)
...