Kia Niro: Engine Control System / Mass Air Flow Sensor (MAFS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Mass Air Flow Sensor (MAFS) Repair procedures

Inspection

Visually check the MAFS for the following:

–	Correct mounting direction

–	Any contamination, corrosion or damage on connector

–	Clogged or wet air cleaner

–	Deformation or blocked MAFS cylinder by foreign material

2.	Check for any leakage on intake system and intercooler system.

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Disconnect the mass air flow sensor connector (A) and the installation clamp (B).

Remove the mass air flow sensor (C).

Mass air flow sensor mounting bolt :

3.9 - 5.8 N·m (0.4 - 0.6 kgf·m, 2.8 - 4.3 lb·ft)

Mass air flow sensor clamp mounting screw :

2.9 - 4.9 N·m (0.3 - 0.5 kgf·m, 2.2 - 3.6 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Be careful not to damage the sensing element and the honey cell.

1.	Install in the reverse order of removal.

Mass Air Flow Sensor (MAFS) Schematic diagrams

Circuit Diagram Harness Connector ...

Intake Air Temperature Sensor (IATS) Specifications

Specification Temperature Resistance (kΩ) °C °F -40 -40 40.93 - 48.35 ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surging" (repeated alternating acceleration an ...

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft. 1. Transponder ...