Peugeot 2008: Driving / Manual parking brake
Release
- Pull the parking brake lever up slightly, press the release button, then lower the lever fully.
When driving the vehicle, if
this warning lamp and the STOP warning lamp come on, accompanied by an
audible signal and the display of a message, this means that the parking brake
is still applied or has not been fully released.
Application
- Pull the parking brake lever up to immobilise the vehicle.
When parking on a slope,
turn the wheels against the kerb, apply the parking brake, engage a gear and
switch off the ignition.
Starting / Switching off the engine with Keyless Entry and Starting
The
electronic key must be present in the passenger compartment.
For versions equipped with Proximity Keyless Entry and Starting, the
electronic key is also detected in the boot.
If it is not detec ...
Electric parking brake
In automatic mode, this system applies the parking brake when the engine is
switched off and releases it when the vehicle moves off.
At any time, with the engine running:
to apply the parking brak ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Resolver Sensor Repair procedures
Inspection
Hybrid Drive Motor
1.
Inspect the resolver sensor resistance.
Item
Pin
Specification
Remarks
Resistance
(Resolver sensor)
1 - 5 ...
Toyota Corolla 2019-2022 Owners Manual: Selecting wheel set
Your vehicle is equipped with tire pressure warning system with the function
to have ID codes registered for a second wheel set, for example a winter set, by
Toyota dealer.
After registration of a second wheel set, either of these two wheel sets can
be selected for usage with the tire pressure wa ...
