Kia Niro: Dual Clutch Transmission Control System / Input Speed Sensor Repair procedures

Removal
1.

Remove the clutch actuator.

(Refer to Dual Clutch Transmission Control System - "Clutch Actuator Assembly")

2.

Remove the connector from the bracket after disconnecting the connector and then remove the input speed sensor (A).

Tightening torque :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Installation
1.

Install in the reverse order of removal.

  

Before installing the input speed sensor, check the assembled state of the O-rings (A) and apply gear oil to the surface of O-rings.

Input Speed Sensor Schematic diagrams
Schematic Diagrams ...

Inhibitor Switch Components and components location
Component Location 1. Inhibitor switch 2. Manual control lever ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Body Control Module (BCM) 2. Ultrasonic sensor    Front/rear parking assist control unit function is built into the Body Control Module (BCM). ...

Kia Niro 2017 (DE HEV) Service Manual: Luggage Side Trim Components and components location
Component Location 1. Luggage side trim ...

© 2016-2026 www.kniro.net