Kia Niro: Air Conditioning System / In-car Sensor Repair procedures
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a remover, remove the crash pad side cover [RH] (A).
|
| 3. |
Loosen the screw and remove the crash pad plate [RH] (A)
|
| 4. |
Remove the start stop button connector (A).
|
| 5. |
Lower and remove the center fascia panel (A).
|
| 6. |
Loosen the screw and remove the heater and air conditioner control unit (A).
|
| 7. |
Remove the heater and the air conditioning control unit connector (A).
|
| 8. |
Disconnect the room temperature sensor connector (A).
|
| 9. |
Press the fixing pin and remove the room temperature sensor (A).
|
| 10. |
Install in the reverse order of removal.
|
In-car Sensor Description and operation
Description
The in-car air temperature sensor is built into the heater & A/C control unit.
The sensor consists of a thermistor that measures the temperature inside the
vehicle. T ...
Photo Sensor Description and operation
Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar
radiation received by ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: Exhaust Heat Recovery System(EHRS) Description and operation
Description and Operation
During cold start or in winter, the fuel efficiency can be improved by heating
up the coolant with the exhaust gas heat discharged after combusting the engine.
When the engine has been sufficiently warmed up, the valve on the passage of exhaust
gas is ope ...
Kia Niro 2017 (DE HEV) Service Manual: A/C Pressure Transducer Repair procedures
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output
between terminals "1" and “2”.
2.
Check if the voltage is within specification.
Voltage = 0.00878835 * Pressure + ...
