Kia Niro: Immobilizer System / Immobilizer Control Unit Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the main crash pad assembly.

(Refer to Body - "Main Crash Pad Assembly")

3.

Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a bolt.

Installation
1.

Install the immobilizer control unit after connecting the unit connector.

2.

Install the main crash pad assembly.

3.

Connect the negative (-) battery terminal.

Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. ...

Antenna Coil Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel&quo ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: License Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after pressing the locking pin. 3. Disconnect the license lamp connector (A). 4. ...

Kia Niro 2017 (DE HEV) Service Manual: Safety Plug Description and operation
Description Safety Plug is installed on the rear side of the high voltage battery and it can mechanically shut the high voltage circuit off when servicing the high voltage system (i.e. High Voltage Battery, Power Relay Assembly, HPCU, BMS ECU, Hybrid Drive Motor, Inverter, HSG, LD ...

© 2016-2023 www.kniro.net