Kia Niro: Ignition System / Ignition Coil Repair procedures

Removal

1.	Turn ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Remove the engine cover.

3.	Disconnect the ignition coil connector (A).

Remove the ignition coil (A) after loosening the mounting bolt.

Ignition coil mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 Ib·ft)

When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

Installation

1.	Install in the reverse order of removal.

Circuit Diagram Ignition Coil Connector Terminal Function Connector View Ignition Coil Terminal Function Ignition Coil (Cylinder #1) ...

Specification Item Specification Type ELR9ISP8+ Gap 0.7 - 0.8 mm (0.0276 - 0.0314 in.) ...

Kia Niro 2017 (DE HEV) Service Manual: DCT Control Module (TCM) Schematic diagrams
TCM Connector TCM Terminal Function Connector [A] Pin Description Pin Description 1 Clutch actuator (Clutch motor 1 (Odd)_Phase V) 15 Clutch actuator (Clutch motor ...

Kia Niro 2017 (DE HEV) Service Manual: Rear Back Armrest Repair procedures
Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pie ...