Peugeot 2008: Technical data / Identification markings

Various visible markings for the identification and research of your vehicle.

Peugeot 2008. Identification markings

  1. Vehicle identification number (VIN), under the bonnet.

    Stamped on the chassis.

  2. Vehicle identification number (VIN), on the dashboard.

    On a label, visible through the windscreen.

  3. Manufacturer's label.

    Fixed at the right-hand door.

    Bears the following information:

    • Manufacturer’s name.
    • European whole vehicle type approval number.
    • Vehicle identification number (VIN).
    • Gross vehicle weight (GVW).
    • Gross train weight (GTW).
    • Maximum weight on the front axle.
    • Maximum weight on the rear axle.
  4. Tyres / paint code label.
  5. Fixed at the driver-side door.

Bears the following information about the tyres:

spare tyre inflation pressure.

Also indicates the paint colour code.

Peugeot 2008. Identification markings The vehicle may be originally equipped with tyres with higher load and speed indices than those indicated on the label, without affecting tyre pressure (on cold tyres).

Dimensions
These dimensions have been measured on an unladen vehicle. ...

PEUGEOT Connect Radio
Multimedia audio system - Applications - Bluetooth® telephone The functions and settings described vary according to the vehicle version and configuration, as well as the country of sale. For s ...

Other information:

Kia Niro (DE HEV) Owners Manual: Immobilizer Indicator Light (Without Smart Key)
This indicator light illuminates: • When the vehicle detects the immobilizer in your key properly while the ignition switch is ON. - At this time, you can start the engine. - The indicator light goes off after starting the engine. This indicator light blinks: • When there is a malfuncti ...

Kia Niro 2017 (DE HEV) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS during idle with IG ON. Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] ...

© 2016-2023 www.kniro.net