Kia Niro: Heating, Ventilation and Air Conditioning / High voltage shut-off procedures

Kia Niro 2017 (DE HEV) Service Manual / Heating, Ventilation and Air Conditioning / High voltage shut-off procedures

High Voltage Shut-off Procedures

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to read and follow the “High Voltage Shut-off Procedures” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

High voltage components:

High Voltage Battery Pack Assembly, Power Relay Assembly (PRA), BMS ECU, Hybrid Power Control Unit (HPCU), Hybrid Drive Motor, HSG, Electric A/C Compressor, Low DC/DC Converter (LDC), Power Cable, Electric Compressor etc.

1.	Switch "OFF" the ignition and disconnect the negative (-) terminal of the auxiliary 12V battery.

2.	Remove the safety plug cover (A) under the rear seat.

3.	Unfasten the hook (A) in the direction of the arrow.

4.	Unfasten the lever (A) in the direction of the arrow.

5.	Remove the safety plug (A).

6.	Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged.

Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely.

(1)	Remove air cleaner assembly and air duct. (Refer to Engine Mechanical System – “Air Cleaner”)

(2)

Disconnect the inverter power cable (A).

Disconnect the inverter power cable as shown below.

(3)

Measure the voltage between the inverter (+) terminal and the inverter (-) terminal.

Less than 30V : High voltage circuit properly shut

More than 30V : Fault on high voltage circuit

If measured more than 30V, check if the safety plug is removed completely. If measured more than 30V despite the safety plug is removed, there can be serious problem on the high voltage circuit. In this case, check DTC and do not touch the high voltage system circuits.

General safety information and caution

Safety Precaution Precautions to take before servicing high voltage system ...

Specifications

Specification Air Conditioner Item Specification Compressor Type HES27 (Electric Scroll) Communicatio ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Intake Actuator Repair procedures
Inspection 1. Switch "OFF" the ignition. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding termin ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Component Location 1. Engine 2. Hybrid Drive Motor Assembly 3. Hybrid Starter Generator (HSG) 4. Transaxle 5. High Voltage Battery System Assembly 6. Power Cable ...