Kia Niro: Headlamp and front fog lamp aiming / Headlamp aiming

1. Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools.

2. The vehicle should be placed on a flat floor.

3. Draw vertical lines (Vertical lines passing through respective head lamp centers) and a horizontal line (Horizontal line passing through center of head lamps) on the screen.

4. With the head lamp and battery in normal condition, aim the head lamps so the brightest portion falls on the horizontal and vertical lines.

5. To aim the low and high beams left or right, turn the driver (1) clockwise or counterclockwise. To aim the low and high beams up or down, turn the driver (2) clockwise or counterclockwise.

Headlamp and front fog lamp aiming
...

Front fog lamp aiming
The front fog lamp can be aimed as the same manner of the head lamps aiming. With the front fog lamps and battery normal condition, aim the front fog lamps. To aim the front fog lamp up or down, t ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Brake Actuation Unit Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the TCM connector. (Refer to DCT (Dual Clutch Transmission) System - "DCT Control Module (TCM)) 3. Disco ...

Kia Niro (DE HEV) Owners Manual: Operating conditions
The indicator on the switch will illuminate when the Blind spot detection system switch is pressed with the ignition switch ON. If the vehicle speed exceeds 30 km/h (18.6 mph), the system will activate. If you press the switch again, the switch indicator and system will be turned off. If t ...

© 2016-2025 www.kniro.net