Kia Niro: Headlamp and front fog lamp aiming / Head lamp low beam (RHD)

1. Turn the low beam on without driver aboard.

2. The cut-off line should be projected in the cut-off line shown in the picture.

3. When aiming the low beam, vertical aiming should be adjusted after adjusting the horizontal aiming.

4. If head lamp leveling device is equipped, adjust the head lamp leveling device switch with 0 positions.

A : Vertical line of the left fog lamp bulb center
B : Vertical line of the right fog lamp bulb center
C : Horizontal line of fog lamp (low) bulb center
D : Cut – Off line
E : Car Axis
F : Upper limit
G : Ground

Head lamp low beam (LHD)
1. Turn the low beam on without driver aboard. 2. The cut-off line should be projected in the cut-off line shown in the picture. 3. When aiming the low beam, vertical aiming should be adjusted after ...

Front fog light
1. Turn the front fog lamp on without the driver aboard. 2. The cut-off line should be projected in the allowable range (shaded region). ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rail Pressure Sensor (RPS) Specifications
Specification Pressure Output Voltage (V) [Vref=5V] bar [MPa (kgf/cm², psi)] 0 0 (0, 0) 0.5 140 14 (142, 2031) 2.5 280 ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Removal 1. Disconnect the battery negative cable. 2. Turn the steering wheel so that the front wheels are facing straight ahead. 3. Remove the driver airbag module. (Refer to Restraint - "Driver Airbag (DAB) ...

© 2016-2023 www.kniro.net