Kia Niro: Road warning / Hazard warning flasher
■ Type A
■ Type B
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
- The hazard warning flasher operates whether your vehicle is running or not.
- The turn signals do not work when the hazard flasher is on.
- Care must be taken when using the hazard warning flasher while the vehicle is being towed.
Road warning
...
In case of an emergency while driving
If the engine stalls at a crossroad or crossing
• If the engine stalls at a crossroad or crossing, set the shift lever in the
N (Neutral) position and then push the vehicle to a safe place.
If y ...
Other information:
Kia Niro 2017 (DE HEV) Service Manual: BJ Boot Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove the Dynamic damper.
...
Kia Niro 2017 (DE HEV) Service Manual: Windshield Wiper-Washer Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
3.
Remove the steering column upper and lower shrouds after loosening the ...
