Kia Niro: Fuel Delivery System / Fuel Pump Repair procedures

Inspection

[Fuel sender]

1.	Turn the ignition switch OFF, and then remove battery (-) terminal.

2.	Remove the fuel pump assembly.

Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level.

Pin No.	Description
1	Fuel Sender (-)
2	Fuel pressure sensor (FPS) signal input
3	Fuel pressure sensor (FPS) ground
4	Ground (-)
5	CAN [Low]
6	Fuel Sender (+)
7	-
8	Fuel Pressure Sensor (FPS) Power [+5V]
9	CAN [High]
10	Battery Power (B+)

Also check that the resistance changes smoothly when the float moves from "E" to "F".

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")

3.	Fuel pump service cover (A).

4.	Remove the fuel pump control module connector (A).

5.	Disconnect the fuel pressure sensor connector (B).

6.	Disconnect the fuel feed tube quick-connector (C).

7.	Remove the fuel pump plate cover (B) by using the special service tool (A) [SST NO.:09310-B8100].

8.	Remove the fuel pump (A).

Installation

Install in the reverse order of removal.

Carefully note the fuel pump direction during installation.

Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the rear seat cushion. (Refer to ...

Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the fuel pump motor connector (A) and f ...

Kia Niro 2017 (DE HEV) Service Manual: Air Conditioner Refrigerant/Compressor Repair procedures
Refrigerant Recovery Use only U.L.-listed service equipment certified to meet the requirements of SAE J2210 when removing HFC-134a (R-134a) from the air conditioning system. • Air conditio ...

Kia Niro 2017 (DE HEV) Service Manual: Audio Unit Components and components location
Components [RADIO/CD/MP3] Connector Pin Information No. Connector A Connector B 1 Rear left speaker (+) - 2 Rear left speaker (-) MIC (+) ...