Kia Niro: Fuel Delivery System / Fuel Pressure Sensor (FPS) Repair procedures

Inspection
1.

Connect the KDS/GDS on the Data Link Connector (DLC).

2.

Check that the output voltage is within the specification.

Pressure [kPa (kgf/cm², psi)]
Output Voltage (V) [Verf=5V]
50 (0.51, 7.3)
0.3
600 (6.12, 87.0)
2.5
1100 (11.2, 159.5)
4.5

Removal
1.

Release the residual pressure in fuel line.

(Refer to Fuel Delivery system - "Release Residual Pressure in Fuel Line")

2.

Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

3.

Remove the rear seat cushion.

( Refer to Body - "Rear Seat Assembly" )

4.

Remove the fuel pump service cover (A).

5.

Disconnect the fuel pressure sensor connector (A).

6.

Remove the fuel pressure sensor fixing pin (A).

7.

Remove the fuel pressure sensor (B) from the fuel pump.

Installation
1.

Install in the reverse order of removal.

Fuel Pressure Sensor (FPS) Schematic diagrams
Circuit Diagram Fail-Safe Mode Item Fail-Safe Output Voltage (V) 12    ...

Delivery Pipe Repair procedures
Removal    In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, th ...

Other information:

Kia Niro (DE HEV) Owners Manual: Coat hook
❈ This actual feature may differ from the illustration. A Coat hook is next to the rear grab handle. CAUTION Do not hang heavy clothes, since those may damage the hook. WARNING Do not hang other objects such as hangers or hard objects except clothes. Also, do not put heavy, sharp or bre ...

Kia Niro 2017 (DE HEV) Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. [Throttle Position Sensor (TPS)] ...

© 2016-2026 www.kniro.net