Kia Niro: Blade replacement / Front windshield wiper blade

Type A

1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.

CAUTION

Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.

2. Compress the clip and slide the blade assembly downward.

3. Lift it off the arm.

4. Install the blade assembly in the reverse order of removal.

Type B

1. Raise the wiper arm.

CAUTION

Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.

2. Turn the wiper blade clip. Then lift up the blade clip.

3. Push the clip (1) and push up the wiper arm (2).

4. Push down the wiper arm (3) and install the new blade assembly in the reverse order of removal.

5. Return the wiper arm on the windshield.

Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. CAUTION To prevent damage to the wiper arms or other components, do not attempt to move th ...

Rear window wiper blade
1. Raise the wiper arm and pull out the wiper blade assembly. 2. Install the new blade assembly by inserting the center part into the slot in the wiper arm until it clicks into place. 3. Make ...

Other information:

Kia Niro (DE HEV) Owners Manual: Low Tire Pressure Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When one or more of your tires are significantly underinflated. ❈ For more details, refer to “Tire Pressur ...

Kia Niro 2017 (DE HEV) Service Manual: In-car Sensor Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Using a remover, remove the crash pad side cover [RH] (A). 3. Loosen the screw and remove the crash pad plate [RH] (A) 4. ...

© 2016-2024 www.kniro.net