Kia Niro: Front Seat / Front Seat Assembly Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement

Loosen the front seat mounting bolts (A).

Tightening torque :

49.0 - 58.8 N·m (5.0 - 6.0 kgf·m, 36.2 - 43.4 lb·ft)

[Front]

[Rear]

2.	Disconnect the airbag connector (A), seat warmer & power seat switch connector (B), front seat belt buckle connector (C), body sensor (D). [Driver side] [Passenger side]

Install in the reverse order of removal.

SEAT MOUNTING BOLT INSTALLATION PROCEDURE

•	Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.

•	Set the seat into the foremost position. Check that each slide is locked, and then tighten the rear mounting bolt completely.

•	Set the seat into the rearmost position. Check that the front mounting bolt is tightened completely.

•	Check that the seat operates to and fro smoothy and the locking portion locks properly.

Front Seat Assembly Components and components location

Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover Components and components location

Component Location 1. Front seat shield outer cover ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Description and operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the seat belt ...

Kia Niro 2017 (DE HEV) Service Manual: Parking Brake Assembly Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3. Remove the knee air bag. (Refer to Restrain ...