Kia Niro: SRSCM / Front Impact Sensor (FIS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal
1.

Disconnect the battery negative terminal, and wait for at least thirty seconds before beginning work.

2.

Disconnect the front impact sensor connector (A).

3.

Loosen the mounting bolts. Remove the front collision detection sensor (B).

Tightening torque:

8.0 - 10.0 N.m (0.8 - 1.0 kgf.m, 5.9 - 7.3 lb-ft)

Installation
1.

Install in the reverse order of removal

  

Do not turn the ignition switch ON and do not connect the battery terminal while replacing the front impact sensor.

Front Impact Sensor (FIS) Components and components location
Components ...

Side Impact Sensor (SIS) Description and operation
Description • Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Brake Actuation Unit Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2. Disconnect the TCM connector. (Refer to DCT (Dual Clutch Transmission) System - "DCT Control Module (TCM)) 3. Disco ...

Kia Niro 2017 (DE HEV) Service Manual: High voltage shut-off procedures
High Voltage Shut-off Procedures    • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure t ...

© 2016-2023 www.kniro.net