Kia Niro: Front Bumper / Front Bumper Cover Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Loosen the radiator upper cover mounting bolts and clips.

2.

Remove the engine under cover (A).

3.

Separate the front bumper side after loosening the front bumper side screws and clips.

  

Remove the front bumper by lifting up and pulling out the side of the front bumper.

4.

Disconnect the front bumper main connector (A).

5.

Remove the front bumper cover (A).

6.

Install in the reverse order of removal.

  

Make sure the connector is connected properly.

Replace any damaged clips.

Front Bumper Cover Components and components location
Component Location 1. Front bumper cover ...

Radiator Grille Components and components location
Component Location 1. Radiator Grille ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Hybrid Power Control Unit (HPCU) Components and components location
Components 1. Hybrid Control Unit(HCU) [HPCU] 2. Inverter [HPCU] 3. Low Voltage DC/DC Converter (LDC) [HPCU] 4. High voltage connector (↔ High voltage battery system assembly) 5. High voltage connector (↔ Hybrid drive motor assembly) 6. H ...

Kia Niro (DE HEV) Owners Manual: Safety chains
You should always attach chains between your vehicle and your trailer. Cross the safety chains under the tongue of the trailer so that the tongue will not drop to the road if it becomes separated from the hitch. Instructions about safety chains may be provided by the hitch manufacturer or by ...

© 2016-2024 www.kniro.net