Kia Niro: AVN System / External AMP Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the crash pad center lower panel.

(Refer to Body - "Crash Pad Center Panel")

3.

Disconnect the external amplifier connectors (A).

4.

Remove the external amplifier (A) after loosening the mounting bolts and nuts.

Installation
1.

Install the external amplifier after connecting the connectors.

2.

Install the crash pad center lower panel.

3.

Connect the negative (-) battery terminal.

  

Make sure that the external amplifier connectors are plugged in properly.

Check the AVN system for normal operation.

External AMP Components and components location
Components Connector Pin Information No. Connector A No. Connector B 1 Battery (+) 1 ...

AVN Antenna Components and components location
Components [Roof Antenna (AM/FM + DAB + GNSS] ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replac ...

Kia Niro 2017 (DE HEV) Service Manual: Components and components location
Components (1) [General Type] 1. Sun visor [LH] 2. Sun visor [RH] 3. Roof trim 4. Assist handle bracket Components (2) [Sunroof Type] 1. Sun visor [LH] 2. Sun visor [RH] ...

© 2016-2026 www.kniro.net