Kia Niro: Intake And Exhaust System / Exhaust Heat Recovery System(EHRS) Description and operation
| Description and Operation |
During cold start or in winter, the fuel efficiency can be improved by heating up the coolant with the exhaust gas heat discharged after combusting the engine. When the engine has been sufficiently warmed up, the valve on the passage of exhaust gas is opened to block the heat exchange of exhaust gas and coolant, thus to prevent overheating of coolant. The valve of the exhaust gas passage is opened and closed by the operation of wax actuator according to the temperature of coolant. To monitor the temperature of coolant, a separate water temperature sensor (WTS) is installed, and in the event of overheated coolant [over 120°C (248°F], the engine overheating warning lamp in the cluster is illuminated.
[Coolant Flow Chart]
Exhaust Manifold Repair procedures
Removal and Installation
1.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.
...
Exhaust Heat Recovery System(EHRS) Troubleshooting
Troubleshooting
Symptom
Inspection
Remedy
Overheating
• Engine overheating
• Temperature gauge rising to HI
...
Other information:
Kia Niro (DE HEV) Owners Manual: Lap belt
To fasten your seat belt:
To fasten a 2-point static type belt, insert the metal tab (1) into the locking
buckle (2). There will be an audible "click" when the tab locks into the buckle.
Check to make sure the belt is properly locked and that the belt is not twisted.
With a 2-p ...
Kia Niro 2017 (DE HEV) Service Manual: Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with an L wrench (A).
Tightening torque :
9.81 - 14.71 N·m (1.0 - 1.5 kgf·m, 7.2 - 10.8 lb·ft)
...
