Kia Niro: Air Conditioning System / Evaporator Temperature Sensor Repair procedures

Inspection
1.

Switch "OFF" the ignition.

2.

Disconnect the evaporator temperature sensor connector.

3.

Measure the resistance between positive (+) and negative (-) terminals of the evaporator temperature sensor.

Specification

Evaporator core temperature
[°C (°F)]
Resistance [k?]
Voltage [V]
-10 (14)
43.35
2.96
0 (32)
27.62
2.40
10 (50)
18.07
1.88
20 (68)
12.11
1.44
30 (86)
8.30
1.08
40 (104)
5.81
0.81

1. Evaporator sensor (+)
2. Sensor ground

Replacement
1.

Remove the evaporator core.

(Refer to Air Conditioner - "Evaporator Core".)

2.

Remove the evaporator temperature sensor (A).

3.

Install in the reverse order of removal..

Evaporator Temperature Sensor Description and operation
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessiv ...

In-car Sensor Description and operation
Description The in-car air temperature sensor is built into the heater & A/C control unit. The sensor consists of a thermistor that measures the temperature inside the vehicle. T ...

Other information:

Kia Niro (DE HEV) Owners Manual: Warning message
The message (“Blind Spot Detection disabled temporarily”) will appear to notify the driver if there are foreign substances on the rear bumper or it is hot near the rear bumper. The light on the switch and the system will be turned off automatically. Remove the foreign substance on the rear ...

Kia Niro 2017 (DE HEV) Service Manual: Concentric Slave Cylinder Assembly Repair procedures
Removal 1. Remove the hybrid motor assembly. (Refer to Hybrid Motor System - "Hybrid Motor Assembly") 2. Remove the engine clutch actuator. (Engine Clutch System - "Engine Clutch Actuator") 3. ...

© 2016-2023 www.kniro.net