Peugeot 2008: Indicators / Engine oil level indicator

(Depending on version.)

On versions fitted with an electric gauge, the engine oil level status is displayed on the instrument panel for a few seconds when the ignition is switched  on, after the servicing information.

Peugeot 2008. Engine oil level indicator The level read will only be correct if the vehicle is on level ground and the engine has been off for more than 30 minutes.

Oil level incorrect

This is indicated, depending Oil level incorrecton the instrument panel, by the display of "OIL" or by the message "", accompanied by the lighting of the Service warning lamp and an audible signal.

If the low oil level is confirmed by a check using the dipstick, the level must be topped up to avoid damage to the engine.

For more information on Checking levels, refer to the corresponding section.

Gauge fault

This is indicated, depending on the instrument panel, by the display of "OIL_ _" or by the message "Oil level measurement invalid", warning lamp and an audible signal.

Contact a PEUGEOT dealer or a qualified workshop

Peugeot 2008. Engine oil level indicator In the event of a fault with the electric gauge, the oil level is no longer monitored.

 If the system is faulty, you must check the engine oil level using the manual dipstick located under the bonnet.

For more information on Checking levels, refer to the corresponding section.

Service indicator
The servicing information is expressed in terms of distance (kilometres or miles) and time (months or days). The alert is given at whichever of these two terms is reached first. The servicing informa ...

Engine coolant temperature indicator
With the engine running: In zone A, the temperature is correct. In zone B, the temperature is too high; the associated warning lamp and the central STOP warning lamp come on in red on the instrument ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Inhibitor Switch Repair procedures
Inspection    Inspect the following items by referring to inspection flow chart. (Refer to Inhibitor Switch - "Troubleshooting") 1. Check the diagnostic trouble codes (DTC) usin ...

Kia Niro 2017 (DE HEV) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the KDS/GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS during idle with IG ON. Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] ...

© 2016-2023 www.kniro.net