Refer to the General recommendations on the use of driving and manoeuvring aids.
Take a break in case of feeling tired or at least every 2 hours.
The function comprises the "Driver Attention Alert" system combined with the "Driver Attention Alert by camera" system.
These
systems are in no way designed to keep the driver awake or to prevent the driver
from falling asleep at the wheel.
It is the driver’s responsibility to stop if feeling tired.
Activation / Deactivation
It is set via the Driving /
Vehicle touch screen menu.
The state of the system stays in the memory when the ignition is switched off.
Driver Attention Alert
The system triggers an alert as
soon as it detects that the driver has not taken a break after two hours of
driving at a speed above 40 mph (65 km/h).
This alert is issued via the display of a message encouraging the driver to take a break, accompanied by an audible signal.
If the driver does not follow this advice, the alert is repeated hourly until the vehicle is stopped.
The system resets itself if one of the following conditions is met:
As
soon as the speed of the vehicle drops below 40 mph (65 km/h), the system goes
into standby.
The driving time is counted again once the speed is above 40 mph (65 km/h).
Driver Attention Alert by camera
Using a camera placed at the top
of the windscreen, the system assesses the driver's level of vigilance, fatigue
or distraction by identifying variations in trajectory compared to the lane
markings.
This system is particularly suited to fast roads (speed higher than 40 mph (65 km/h)).
At a first-level alert, the driver is warned by the “Take care!” message, accompanied by an audible signal.
After three first-level alerts, the system triggers a further alert with the message "Dangerous driving: take a break", accompanied by a more pronounced audible signal.
In
certain driving conditions (poor road surface or strong winds), the system may
give alerts independent of the driver's level of vigilance.
The
following situations may interfere with the operation of the system or prevent
it from working:
Kia Niro (DE HEV) Owners Manual: Rear window wiper blade
1. Raise the wiper arm and pull out the wiper blade assembly.
2. Install the new blade assembly by inserting the center part into the slot
in the wiper arm until it clicks into place.
3. Make sure the blade assembly is installed firmly by trying to pull it slightly.
To prevent damage to the ...
Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Safety Precaution
Precautions to take before servicing
high voltage system
Hybrid vehicles have high voltage batteries. Incorrect handling
of high voltage sy ...