Kia Niro: Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS) Repair procedures

Inspection

Check signal waveform of CKPS and CMPS using a KDS/GDS.

Specification: Refer to “Waveform”

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the air cleaner. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Disconnect the crankshaft position sensor connector (A).

4.	Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Remove the crankshaft position sensor after loosening the mounting bolt (A).

Crankshaft position sensor mounting bolt :

9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)

Installation

•	Install the component to the specified torque.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply engine oil to the O-ring.

•	Insert the sensor in the installation hole and be careful not to damage it.

1.	Install in the reverse order of removal.

Crankshaft Position Sensor (CKPS) Schematic diagrams

Circuit Diagram Harness Connector ...

Crankshaft Position Sensor (CKPS) Troubleshooting

Signal Waveform This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveforms at idle. The PCM controls the injection and ignition tim ...

Other information:

Kia Niro (DE HEV) Owners Manual: For best battery service
Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease. Rinse any spilled electrolyte from the battery immediately with a solution of water and baking soda. If the v ...

Kia Niro (DE HEV) Owners Manual: Blind spot detection system
The Blind spot detection system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ Blind spot detection Warning range is dependent on your vehicle speed. However, if the speed of your vehicle ...