Kia Niro: High Voltage Battery Cooling System / Cooling Fan Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Service Highlight / High Voltage Battery Cooling System / Cooling Fan Repair procedures

Removal

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to shut off the high voltage before doing any work related with the high voltage system(Refer to "High Voltage Shut-off Procedure"). Failure to follow the safety instructions may result in serious electrical injuries.

1.	Shut off the High Voltage circuit. (Refer to Hybrid Control System - “High Voltage Shutoff Procedure”)

2.	Remove the high voltage battery front cover. (Refer to High Voltage Battery System - "Case")

3.	Disconnect the cooling fan connector (A).

Remove the cooling fan (B) after loosening the mounting bolt and nuts.

cooling fan mounting nut / bolt :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Installation

•	Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.

•	Be sure to shut off the high voltage before doing any work related with the high voltage system(Refer to "High Voltage Shut-off Procedure"). Failure to follow the safety instructions may result in serious electrical injuries.

1.	Install the cooling fan in the reverse order of removal.

Inspection

1.	Connect the KDS/GDS to the Data Link Connector (DLC).

Connect the oscilloscope probe to the BMS extension connectors.

Cooling Fan Speed Waveform:

BMS Extension Connector B01-S(20)

Cooling Fan Feedback Waveform:

BMS Extension Connector B01-S(4)

3.	Turn the ignition switch ON.

Check “Fan Status”, “Current” "Waveform" and waveforms in each cooling fan operation mode by using “Actuation Test” function in KDS/GDS.

Duty

Duty (%)	Fan Speed (rpm)
10	-
20	1,000
30	1,300
40	1,600
50	1,900
60	2,200
70	2,500
80	2,800
90	3,100
95	3,850

[Cooling Fan at 1st]

[Cooling Fan at 2st]

[Cooling Fan at 3st]

[Cooling Fan at 4st]

[Cooling Fan at 5st]

[Cooling Fan at 6st]

[Cooling Fan at 7st]

[Cooling Fan at 8st]

[Cooling Fan at 9st]

Cooling Fan Description and operation

Description The cooling Fan consists of the main connector, the cooling fan relay and the BLDC motor. It is controlled by the BMS ECU PWM signal which varies with the high voltage bat ...

Low Voltage DC/DC Converter (LDC)

...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Front Bumper Cover Components and components location
Component Location 1. Front bumper cover ...

Kia Niro 2017 (DE HEV) Service Manual: Quarter Garnish Repair procedures
Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove interior trim pie ...