Kia Niro: Blind Spot Detection system (BSD) / Blind Spot Detection Unit Repair procedures

Kia Niro 2017 (DE HEV) Service Manual / Body Electrical System / Blind Spot Detection system (BSD) / Blind Spot Detection Unit Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover")

3.	Disconnect the BSD connector (A).

4.	Remove the BSD unit (A) after loosening the mounting nuts.

Installation

1.	Place the RH and LH radar sensors on each side to get ready for installation.

Install the radar sensor to the bracket correctly (distinguish RH & LH) with mounting nuts.

•	The shapes of the LH and RH blind spot detection units are different. Therefore, take notice when installing the blind spot detection units.

•	Radar Sensors must be closed up against the bracket completely.

•	After mounting radar sensors, check for looseness.

3.	Install the rear bumper cover.

4.	Connect the negative (-) battery terminal.

Blind Spot Detection Unit Schematic diagrams

Circuit Diagram ...

Blind Spot Detection Radar Calibration Description and operation

Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD unit al ...

Other information:

Kia Niro (DE HEV) Owners Manual: Map lamp
■ Type A ■ Type B • (2) : - The map lamp and room lamp comes on when a door is opened. The lamps go out after approximately 30 seconds. - The map lamp and room lamp comes on for approximately 30 seconds when doors are unlocked with a transmitter or smart key as long as the doors a ...

Kia Niro (DE HEV) Owners Manual: Power outlet
The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engine running. CAUTION Use the power outlet only when the engine is running and remove the accessor ...