Kia Niro: Blind Spot Detection system (BSD) / Blind Spot Detection Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the crash pad plate [LH] (A) after loosening the screws.
|
| 4. |
Disconnect the crash pad side switch connector (A).
|
| 5. |
Remove the crash pad side switch (A) after loosening the screws.
|
| Installation |
| 1. |
Install the crash pad side switch. |
| 2. |
Connect the crash pad side switch connector. |
| 3. |
Install the crash pad plate [LH]. |
| 4. |
Install the crash pad lower panel. |
| 5. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Disconnect the BSD switch connector from the crash pad side switch.
|
| 2. |
Operate the BSD switch, then check for continuity between terminals and BSD switch connector.
|
Blind Spot Detection Switch Schematic diagrams
Circuit Diagram
...
Blind Spot Detection Indicator Components and components location
Components
1. BSD Indicator
2. Side repeater lamp
...
Other information:
Kia Niro (DE HEV) Owners Manual: Service Mode
Service in
It calculates and displays when you need a scheduled maintenance service (mileage
or days).
If the remaining mileage or time reaches 1,500 km (900 mi.) or 30 days, “Service
in” message is displayed for several seconds each time you set the ignition switch
or Engine Start/Sto ...
Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Safety Precaution
Precautions to take before servicing
high voltage system
Hybrid vehicles have high voltage batteries. Incorrect handling
of high voltage sy ...
