Kia Niro: Blind Spot Detection system (BSD) / Blind Spot Detection Indicator Repair procedures

Removal
Blind Spot Detection Warning Indicator
1.

Disconnect the negative (-) battery terminal.

2.

Remove the mirror (A) from the mirror holder.

3.

Disconnect the mirror heated connector (B) and BSD indicator connector (A).

4.

Remove the BSD indicator (A).

Installation
Blind Spot Detection Warning Indicator
1.

Install the BSD indicator.

2.

Connect the mirror heated connector and BSD indicator connector.

3.

Install the mirror.

4.

Connect the negative (-) battery terminal.

Inspection
1.

Verify that the mirror operates properly as shown in the below table.

Blind Spot Detection Indicator Components and components location
Components 1. BSD Indicator 2. Side repeater lamp ...

Button Engine Start System
...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Rear Seat Back Cover Components and components location
Component Location 1. Rear seat back cover [RH] 2. Rear seat back cover [LH] ...

Kia Niro 2017 (DE HEV) Service Manual: Repair procedures
Inspection 1. Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column. 2. Check for continuity between the terminals. 3. If continuity is not specifi ...

© 2016-2023 www.kniro.net