Kia Niro: AVN System / AVN Antenna Repair procedures

Removal

Roof antenna

1.

Disconnect the negative (-) battery terminal.

2.

Remove the roof trim assembly.

(Refer to Body - "Roof Trim Assembly")

3.

Disconnect the roof antenna cable and connectors (A).

4.

Remove the roof antenna (B) after loosening a nut (A).

Installation

Roof anenna

1.

Install the roof antenna.

2.

Connect the roof antenna connectors.

3.

Install the roof trim assembly.

4.

Connect the negative (-) battery terminal.

  

Make sure that the cables and connectors are plugged in properly.

Check the AVN system for normal operation.

AVN Antenna Components and components location
Components [Roof Antenna (AM/FM + DAB + GNSS] ...

AVN Remote Controller Components and components location
Components 1. Left Remote Control Switch (Audio + Hands free + Voice) 2. Right Remote Control Switch (Cruise+Trip Computer) ...

Other information:

Kia Niro (DE HEV) Owners Manual: Outside (fresh) air position
With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected. ✽ NOTICE Prolonged operation of the heater in the recirculated air position (without air conditioning selected) may cause fogging of the windshiel ...

Kia Niro 2017 (DE HEV) Service Manual: Side Impact Sensor (SIS) Description and operation
Description • Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH) and two rear SI ...

© 2016-2022 www.kniro.net