Kia Niro: Air Conditioning System / A/C Pressure Transducer Repair procedures

Inspection
1.

Measure the pressure of high pressure line by measuring voltage output between terminals "1" and “2”.

2.

Check if the voltage is within specification.

Voltage = 0.00878835 * Pressure + 0.37081095

3.

If the measured voltage is not wihtin specification, replace the A/C pressure transducer.

Replacement
1.

Disconnect the negative (-) battery terminal.

2.

Recover the refrigerant with a recovery/charging station.

  

If PAG oil mixes into the POE oil of the system, dielectric breakdown may occur due to decreased volumetric resistivity and the A/C compressor may not work.

3.

Disconnect the A/C pressure transducer connector (A).

4.

Remove the A/C pressure transducer (A).

  

Be careful not to bend the liquid & suction pipe.

5.

Install in the reverse order of removal.

  

When installing, replace it with a new O-ring (A).

A/C Pressure Transducer Description and operation
Description A/C pressure transducer measures the pressure in high pressure line and converts it into voltage. Based on the converted voltage, engine ECU controls cooling fan by operat ...

Evaporator Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit&qu ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Compressor Schematic diagrams
Schematic Diagrams Connector Pin Connector Pin Function Connector Pin No. Function A 1 12V Power Ground 2 Climate CAN Low 3 ...

Kia Niro 2017 (DE HEV) Service Manual: Front Strut Assembly Repair procedures
Removal 1. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)    Be care ...

© 2016-2024 www.kniro.net