Kia Niro: Body Side Molding / Waist Line Molding Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Using a remover, remove the waist line molding (A).

2.

Install in the reverse order of removal.

  

Replace any damaged clips.

Rear Wheel Guard Repair procedures
Replacement    Put on gloves to protect your hands.    ...

Side Sill Molding Repair procedures
Replacement    Put on gloves to protect your hands.    ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Auto Defogging Sensor Description and operation
Description Installed on the windshield glass, the auto defogging sensor detects humidity to blow out wind for defogging to improve visibility and driver comfort. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by contr ...

Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad plate [LH] (A) after loosening the screws. ...

© 2016-2020 www.kniro.net