Kia Niro: Lighting System / Vanity Lamp Repair procedures

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Detach the vanity lamp (A) using a flat-tip screwdriver.

3.

Disconnect the vanity lamp connector (A).

Bulb Replacement

1.

Detach the vanity lamp (A) using a flat-tip screwdriver.

2.

Remove the vanity lamp bulb (A).

Installation
1.

Connect the vanity lamp connector.

2.

Install the vanity lamp.

3.

Connect the negative (-) battery terminal.

Room Lamp Repair procedures
Removal    • Put on gloves to prevent hand injuries. • ...

Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Other information:

Peugeot 2008 2019-2021 Owner's Manual: Engine coolant temperature indicator
With the engine running: In zone A, the temperature is correct. In zone B, the temperature is too high; the associated warning lamp and the central STOP warning lamp come on in red on the instrument panel, accompanied by the display of a message and an audible signal. You must stop the vehicle as ...

Kia Niro 2017 (DE HEV) Service Manual: Blower Unit Components and components location
Component Location 1. Blower unit assembly Components 1. Blower Intake Seal 2. Intake Duct Case [Upper] 3. Intake Door Assembly 4. Intake Duct Case [Lower] 5. Air Filter Cover 6. Intake Actuator ...

© 2016-2021 www.kniro.net