Kia Niro: Lighting System / Turn Signal Lamp Repair procedures

Removal
Door Mirror Turn Signal Lamp
1.

Disconnect the negative (-) battery terminal.

2.

Remove the mirror (A) from the mirror holder.

  

Be careful not to damage the fixing clips (A).

3.

Disconnect the heating connectors (A) and BSD indicator connector (B) from the mirror.

4.

Remove the door mirror housing (A) after loosening the mounting screws.

5.

Remove the door mirror cover (A) after separating the mounting clips.

6.

Remove the door mirror turn signal lamp (A) after loosening the screw.

7.

Disconnect the connector (A) from the door mirror turn signal lamp (B).

Installation
1.

Install the door mirror turn signal lamp.

2.

Install the door mirror cover.

3.

Install the door mirror housing.

4.

Install the door mirror.

5.

Connect the negative (-) battery terminal.

Headlamps Repair procedures
Inspection 1. Check the battery voltage. (Low beam will be on when the battery voltage is above 9 V.) 2. Check the fuse and relay. ...

Room Lamp Repair procedures
Removal    • Put on gloves to prevent hand injuries. • ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Seat Heater Switch Description and operation
Description Seat Heater Smart Control Technology • To prevent low temperature burn, seat heater temperature will automatically be lowered after a certain period of time. (Low temperature burn condition: Over 30 minutes at 50°C) Seat Heater Smart C ...

Kia Niro 2017 (DE HEV) Service Manual: General safety information and caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries. • ...

© 2016-2019 www.kniro.net