Kia Niro: Rear Suspension System / Trailing Arm Repair procedures

Removal
1.

Disconnect the battery negative cable.

2.

Remove the wheel and tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

  

Be careful not to damage the wheel nuts when removing the wheel and tire.

3.

Remove the parking brake cable pin (A).

4.

Rotates the nut (A) in the counterclockwise direction and then remove the parking cable.

5.

Loosen the parking brake cable nuts (A) and trailing arm nuts (B).

Tightening torque:

(A) 6.8 - 10.7 N·m (0.7 - 1.1 kgf·m, 5.0 - 7.9 lb·ft)

(B) 137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)

  

Set up the transmission jack under the lower arm in order to remove the shock absorber in no-load condition.

6.

Loosen the parking brake cable bracket bolt (A) and trailing arm bolts (B) and then remove the trailing arm.

(A) 8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft)

(B) 98.0 - 117.6 N·m (10.0 - 12.0 kgf·m, 72.3 - 86.7 lb·ft)

7.

Install in the reverse order of removal.

Rear Assist Arm Repair procedures
Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Rear Coil Spring Repair procedures
Removal 1. Disconnect the battery negative cable. 2. Remove the wheel and tire. Tightening torque: 107.9 - 127.5 N·m ( ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Exhaust Manifold Components and components location
Components 1. Exhaust manifold gasket 2. Exhaust manifold 3. Exhaust manifold stay 4. Heat protector ...

Kia Niro 2017 (DE HEV) Service Manual: Pre-Charge Relay Description and operation
Description Built into the Power Relay Assembly (PRA), the Pre-Charge Relay starts to charge the capacitor of the inverter soon after ignition "ON", then it goes out when the capacitor has been fully charged. 1. High Voltage Power Terminal (-) 2. Hig ...

© 2016-2018 www.kniro.net