Kia Niro: Cruise Control system / To set cruise control speed

1. Press the CRUISE / button on the steering wheel, to turn the system on. The cruise indicator light will illuminate.

2. Accelerate to the desired speed, which must be more than approximately 30 km/h (20 mph).

3. Move the lever down (to SET-), and release it at the desired speed. The cruise set indicator light will illuminate. Release the accelerator pedal at the same time. The desired speed will automatically be maintained.

On a steep grade, the vehicle may slow down or speed up slightly while going downhill.

Cruise control switch
CANCEL/O : Cancels cruise control operation. CRUISE / : Turns cruise control system on or off. RES+ : Resumes or increases cruise control speed. SET- : Sets or decreases cruise control speed. ...

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Pre-Charge Resistor Description and operation
Description Built into the Power Relay Assembly (PRA), the Pre-Charge Resistor protects the high voltage circuit by limiting the current while the inverter capacitor is being charged. 1. High Voltage Power Terminal (-) 2. High Voltage Power Terminal (+) 3. ...

Kia Niro 2017 (DE HEV) Service Manual: Receiver-Drier Repair procedures
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with an L wrench (A). Tightening torque : 9.81 - 14.71 N·m (1.0 - 1.5 kgf·m, 7.2 - 10.8 lb·ft) ...

© 2016-2020 www.kniro.net