Kia Niro: Tires and wheels / Tire rotation

To equalize tread wear, it is recommended that the tires be rotated every 12,000 km (7,500 miles) or sooner if irregular wear develops.

During rotation, check the tires for correct balance.

When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, outof- balance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of tire. Replace the tire if you find either of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness.

Refer to “Tire and wheels” in chapter 9.

Disc brake pads should be inspected for wear whenever tires are rotated.

✽ NOTICE

Rotate radial tires that have an asymmetric tread pattern only from front to rear and not from right to left.

WARNING

How to check
Use a good quality gauge to check tire pressure. You can not tell if your tires are properly inflated simply by looking at them. Radial tires may look properly inflated even when they're under ...

Wheel alignment and tire balance
The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Exhaust Heat Recovery System(EHRS) Repair procedures
Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2. Drain the engine coolant. (Refer to Cooling System - "Coolant") ...

Kia Niro 2017 (DE HEV) Service Manual: BMS ECU Schematic diagrams
BMS ECU Terminal And Input/Output Signal Connector [B01-VC] (24pin) : High Voltage Battery Cell Voltage Check Connector Pin No. Description Connected to 1 - - 2 ...

© 2016-2021 www.kniro.net