Kia Niro: Dual Clutch Transmission Control System / Shift Lever Repair procedures

Removal
1.

Shift the gear to "N".

2.

Remove the knob (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.

3.

Remove the floor console assembly.

(Refer to Body - "Floor Console")

4.

Disconnect the main connector (A).

5.

Remove the shift cable.

(1)

Remove the shift cable from the shift lever pim after removing the snap pin (A).

(2)

Remove the cable socket (B) from the shift lever.

6.

Remove the shift lever assembly (B) by loosening bolts and then remove the wiring mounting clips (A).

Tightening torque:

8.8 - 13.7 N·m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb·ft)

Installation
1.

Install in the reverse order of removal.

  

Check that the shift lever and manual control lever are placed in the "N" position.

Shift Lever Components and components location
Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable assembly ...

Shift Cable Components and components location
Components 1. Shift lever knob & boots 2. Shift lever assembly 3. Shift cable assembly ...

Other information:

Kia Niro 2017 (DE HEV) Service Manual: Seat Heater Components and components location
Component Location Front Seat Heater 1. Seat heater unit (Assist seat only) 2. Front seat back heater 3. Front seat cushion heater Front Seat Heater (Air Ventilation) 1. Air ventilation seat unit (A ...

Kia Niro (DE HEV) Owners Manual: Emergency Stop Signal (ESS)
The Emergency Stop Signal system alerts the driver behind by blinking the stop light when the vehicle is braked rapidly and severely. The system is activated when: The vehicle suddenly stops (vehicle speed is over 55km/h and the vehicle deceleration at greater than 7 m/s2) The ABS is act ...

© 2016-2019 www.kniro.net