Kia Niro: Back View Camera System / Repair procedures

Removal
  

In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

1.

Disconnect the negative (-) battery terminal.

2.

Remove the tailgate trim.

(Refer to Body - "Tailgate Trim")

3.

Remove the rear wiper motor.

(Refer to Rear Wiper/Washer - "Rear Wiper Motor")

4.

Loosen the rear view camera mountiong nut (A).

5.

Remove the rear view camera assembly (B) after removing the rear view camera pad (A).

Installation
1.

Install the back view camera assembly.

2.

Install the back view camera pad.

3.

Install the rear wiper motor.

4.

Install the tailgate trim.

5.

Connect the negative (-) battery terminal.

Schematic diagrams
Circuit Diagram ...

Body Control Module (BCM)
...

Other information:

Kia Niro (DE HEV) Owners Manual: Technical Data (18 inch tire)
System voltage: DC 12 V Working voltage: DC 10 - 15 V Amperage rating: MAX. 15A ± 1A (at DC 12V operation) Suitable for use at temperatures: -30 ~ +70°C (-22 ~ +158°F) Max. working pressure: 6 bar (87 psi) Size Compressor: 168 x 150 x 68 mm (6.6 x 5.9 x 2.7 in.) Sealant bottle: 104 x 85 ø ...

Kia Niro 2017 (DE HEV) Service Manual: Mode Control Actuator Components and components location
Components Location 1. Mode control actuator [LH] 2. Mode control actuator [RH] ...

© 2016-2020 www.kniro.net