Kia Niro: Floor Carpet / Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the console assembly.

(Refer to Floor Console - "Floor Console Assembly")

2.

Remove the accelerator pedal.

(Refer to Engine Control System - "Accelerator Position Sensor (APS)")

3.

Remove the front seat assembly.

(Refer to Front Seat - "Front Seat Assembly")

4.

Remove the rear seat assembly.

(Refer to Rear Seat - "Rear Seat Assembly")

5.

Remove the cowl side trim.

(Refer to Interior Trim - "Cowl Side Trim")

6.

Remove the center pillar lower trim.

(Refer to Interior Trim - "Center Pillar Trim")

7.

Remove the luggage side trim.

(Refer to Interior Trim - "Luggage Side Trim")

8.

Remove the floor carpet assembly (A).

9.

Install in the reverse order of removal.

  

Replace any damaged clips

1. Floor carpet

Floor Carpet
...

Floor Console
...

Other information:

Kia Niro (DE HEV) Owners Manual: If you do decide to pull a trailer
Here are some important points if you decide to pull a trailer: Consider using a sway control.You can ask a hitch dealer about sway control. Do not do any towing with your car during its first 2,000 km (1,200 miles) in order to allow the engine to properly break in. Failure to heed this cau ...

Kia Niro 2017 (DE HEV) Service Manual: Blind Spot Detection Radar Calibration Description and operation
Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD unit alignment. If this alignment is not performed as in illustration below, it may cause degradation of ...

© 2016-2018 www.kniro.net