Component Replacement After Deployment |
Before doing any SRS repairs, use the KDS/GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs. |
When the front airbag(s) deployed after a collision, replace the following items.
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inspect the clock spring for heat damage. If any damage found, replace the clock spring. |
When the side/curtain airbag(s) deployed after a collision, replace the following items.
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) for the deployed side(s) |
– |
SRS wiring harnesses |
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
– |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Kia Niro (DE HEV) Owners Manual: Armed stage
Park the vehicle and stop the engine. Arm the system as described below.
Using the folding key
1. Turn off the engine and remove the ignition key from the ignition switch.
2. Make sure that all doors, the engine hood and tailgate are closed and latched.
3. Lock the doors by pressing the lock but ...
Kia Niro 2017 (DE HEV) Service Manual: AC Inverter Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim [RH].
(Refer to Body - "Luggage Side Trim")
3.
Disconnect the AC inverter unit connector (A).
...